Adjust panel sections size to refect scale values

5 posts

5 posts

Adjust panel sections size to refect scale values#1254

By DFD484 - Mon Apr 30, 2018 6:49 am

- Mon Apr 30, 2018 6:49 am #1254

I have created a linear dial widget and I need the section panels for the scales to be more reflective of the values. For example:
When I enter 46.00 as the needle value, it reads 46.00 but points to an area about the 60.00 value area on the section panels and not where it should point.
Is there a way to make the section panels more reflective of the actual values?

Attachments

ME Try 4 Widget.xlsx

(156.79 KiB) Downloaded 1226 times

Re: Adjust panel sections size to refect scale values#1255

By DashboardWidgets - Mon Apr 30, 2018 7:58 am

- Mon Apr 30, 2018 7:58 am #1255

Hi DFD484

We took a quick look at your dashboard. The dial is actually pointing to the correct position. However your scale intervals are all unequal.

The main reason for this is that you have not copied and pasted the scale calculation cells on the "my calculations tab" (cells D22 to D26 have formulas in them). For example, the formula automatically divides the scale interval of 100.80 by 5 to give 20.2.

Feel free to take a look at the updated dashboard attached below.

ME Try 4 Widget - Even Scale.xlsx

(156.78 KiB) Downloaded 1215 times

Perhaps you were looking for the non-linear dial - which allows a non-linear scale and may better serve your needs)?

Feel free to get back in touch if there is anything that is not clear or you require further assistance.

Hope this helps!

Cheers

DashboardWidgets